Garage Door Opener Repair
You may find that your garage door opener has been providing you troubles, so you require to fix it. You can repair it by changing a circuit board, a photo-eye sensor, the primary drive gear, or the set-limit buttons. You can likewise inspect if the safety and security sensing units are functioning appropriately.
Replacing a circuit card
Replacing a motherboard for your garage door opener calls for a few actions and tools. First, you need to turn off the circuit breaker and separate any kind of cords. Next off, open the circuit board cover. This will certainly aid you to detect the trouble as well as establish if you require a new board. Next, remove the old board and its cord connectors.
You can then continue to replace the circuit card. The replacement process is simple as well as takes around 10 minutes. A brand-new motherboard will cost about $80. To shield your new circuit card from power rises, you can acquire a rise protector.
Replacing a photo-eye sensor
Replacing a photo-eye sensing unit can be a rather easy task. First, eliminate the sensor from the door and make sure it is positioned properly. If the sensing unit is angled by any means, it may not be getting the correct signal, which could be creating the blinking lights. If you notice that the photo-eyes are out of alignment, you might need to have actually a technician come and fix the problem.
The photo-eye sensor consists of two items that place outside of the door tracks as well as toward the floor. The photo eyes will have a tiny LED light and must be solid in color. If the light is blinking, its likely the photo-eye is malfunctioning as well as will certainly require to be changed.
Changing a primary drive gear
To change a garage door opener main drive equipment, start by eliminating the cap from the chain wheel. Next off, remove both screws holding the drive equipment to the sprocket setting up. Now, you can unfasten the 3 tension pins. Press them from both sides and after that eliminate them. After that, disconnect the 3 cords from the garage door opener motor. These wires must be white, red, and blue.
When you have eliminated the old equipment, mount a new one. Be sure to oil it well. Put the brand-new gear right into the shaft, ensuring to line up the placing holes. See to it the equipment as well as sprocket assembly are positioned appropriately to ensure smooth operation. Next, use a hammer and also a nail to drive a pin into the new gear.
Changing the set-limit switches
The very first thing you should do if your garage door is not working effectively is to examine the set-limit switches. You may require to adjust them to ensure that the door closes earlier or stops prior to it reaches the flooring. You can inspect this by looking at your garage doors handbook or online.
To adjust the set-limit switches, youll require a screwdriver or socket. Adjust the handle clockwise or counterclockwise till the door moves up and stops, or lowers its distance. To check for proper traveling distance, measure the void from the bottom of the garage door to the ground.
Veteran Garage Door Repair – Keller
204 S Key St Ste 105, Keller, TX 76248, USA
817-769-8488
https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/
![]() |
![]() |
![]() |
![]() |
![]() |
Veteran Garage Door Repair
204 S Main St Ste 105
Keller,TX
76248
817-769-8488
https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/